Replacement wicks for ediSUN, lampADA, birnBOOM

You are here: OPOSSUM design » spare parts » replacement/complementary parts oil lamps

longlife wick made of cotton-coated glass fiber, WITHOUT WICK HOLDER, i.e. without the small metal cylinder.

length approx. 50cm

sufficient for 4 wicks with a length of approx. 12.5 cm

You must thread the wick into your existing wick holder yourself. The best way to do this is to slightly "twist" one end of the wick, hold it firmly directly at this end and "screw" it into the hole on the wide side of the holder. Of course there is no thread in the metal holder, but with a screwing movement the wick can be pushed better into the holder. When the wick sticks out at the other end, carefully pull it to the desired total length and cut it off.

If you want to change the wick of several lamps, first thread all the wick holders one after the other, align them to the desired length and only then cut them off. this is a little easier.

This content cannot be displayed because you have objected to the storage of the cookies necessary for display.

Allow this cookie

Replacement wicks for ediSUN, lampADA, birnBOOM

Article number: OP-0117-4D

Longlife wick made of cotton-coated glass fiber, approx. 50cm long, enough for 4 lamps

8,00 € ()

   Incl. 19 % VAT plus shipping

Cannot be delivered to the following countries:

Shipping within 4-6 working days

Remember for later

(c) OPOSSUM design 2010 All rights reserved: Articles, photos and texts are protected by copyright. Manufacturers and distributors of plagiarism, imitations and other copies will be prosecuted.

We use cookies to optimize our website and give you the best possible online experience. By clicking on “Allow all” you agree to this.

Settings